February 2012

taz1000

when i start my car it will idle at 5000 rpm approx and when i try to rev it ,it will go up to about 9000-10000 then cut out after about 4-5 attemps it will eventually rev but reluctantly but when i drive off it will seem to shudder and sometimes cut out ??? also no lights on dash any ideas ??? Read more

skidpan

update .......totally knackered no compression and vavles bent so new engine required any ideas where to get a good 1 or is it not worth doing ???

...

jondom

car crashed into rear &caused damage .notified insurer & taken particulars & photos.

will now go for repair --loan car will be given . any further things to do or be weary of . Read more

TeeCee

>any further things to do

Note down the details of the various claims farmers that cold call you and pass them on to the Data Protection people?

hillman

I read the article “The problem with bigger wheels” on the HJ column in Saturday’s Telegraph. A reader complained that the 17 in wheels on his Mercedes E320 CD1 have increased the emissions and are costing him £35.00 more in road tax than 16 in wheels would.

Can anyone tell me how the wheel diameter affects the CO2 emissions ? ... Read more

SlidingPillar

And give a worse ride on anything other than a race track, and replacement tyres cost more!

r1cky

Hi my Mondeo stays cold on the gauge unless I'm sat stationary then it will creep up to the bottom of "normal" zone, as soon as I drive off it will shoot back down. It doesn't produce any hot air the air that does come out is slightly warm not enough to defrost the screen without scrapping it and not what it used to be like.

... Read more

mss1tw

No-one's been able to say if the anti-corrosion properties deteriorate.

All those head gaskets can't be wrong.

his nibs

Hi,

... Read more

piston power

Last fuel pump i got overhauled was £600.00 just for the pump you have fitting and a warranty so about £900.00 i think.

Plus the other part, your choice trade it in if it still runs.

Englishbullterrier

Hi HTH, can you tell me the fuse number for the rear wiper motor on a Mk4 Fiesta ?

Regards.............ebt Read more

taz1000

my car will start and idle at about 5000 rpm but as soon as i touch the accelerator it will go up to about 10000 rpm then cut out it will do this about 4 times then it will rev reluctantley ,when driving it will seem to shudder no lights on dash and cut out and seem to miss when driving ???? is it fuel starvation or coil maybe ?? Read more

TRAVELMAN

Hi all! Thanks SO MUCH for the advice so far! I'm not at all technically minded so it's helped greatly! In my search for a 1.4d or less (to keep the £30 tax) thanks to you guys I've narrowed it down to Toyotal yaris (reliability, pre-2005 on PDF, & i think a cam chain not belt), Fiesta 1.4di as choice 2-depending on local availability (more fiestas than yaris's!_.

Could I ask you guys about corsa 1.2di? They seem to be good value-cheap parts & plently around & I think even cheaper on insurance. Do the older models (2002-2005) have PDF filters?... Read more

1litregolfeater

Japanese cars sell on their reputation for reliabilty, I'm not sure if this can be justified any more.

Diesel cars sell on their reputation for economy. These days, I think you have to do over 20,000 miles a year....

redmule

Hi

My 407 2.0 hdi wont start properly unless i give the primer bulb a few squeezes(it will start without the primer but takes a lot of cranking) it drives perfectly once its running.... Read more

rzepekuk

Hi redmule

I have exactly the engine on my car and exactly the same problem, I've been trying to sort the problem out for months now and I just can't fix it, I checked:...

redmule

Hi

My 407 2.0 hdi only starts properly when i have given the primer bulb a few squeezes(it does start without the primer but takes a lot of cranking) once started its fine and drives very well with no problems, could this most likely be a fault with the seal in the fuel filter?, there is no smell of diesel.

al Read more

piston power

It could be but more likley the seals in the primer pump have failed and returning fuel back to tank.

Check return feed for bubbles and check all hoses to primer for splits as air can be sucked in here....