January 2023

Andrei Pruteanu

Hi,

I bought an Audi A4 2008 TFSI petrol last summer and started having problems with it. Went to a garage nearby in SW London and the mechanic told me that it has a broken valve inside the engine and the repair will easily cost over £1000 because it's a big job. The oil pressure light was coming up on the dashboard while I was driving so after a couple of checks and repairs he finally found out that the engine misfires and the broken valve is the cause. If I drive the car for more than 20-30 min the oil pressure and engine lights will come up again. I was told I shouldn't drive it like this because the car might stop at any time. ... Read more

Adampr

A PCV valve would be £200-£300 but is easy enough to check at home (after watching a YouTube video). You just detach a little pipe and give it a shake. I doubt that's it, though. After reading a few other comments, it does seem that your problem is coming from the oil.getting thinner as it heats up. That suggests it's not an inlet valve your garage was talking about. I would take it to VW / Audi specialist (not a main dealer) for a second opinion before spending any more.

movilogo

Lately there are too many spams in this forum.

This type of spams are often quite easy to control. Most forums typically don't allow posts from new accounts unless someone moderates it. ... Read more

Engineer Andy

Thanks. Jim1994 has now left the building.

Thank ye verry much...

offshore

Could anybody please tell me if a Seat Leon extended warranty would typically cover problems with a clutch master cylinder ?

Nb Not sure if that is the problem - clutch pedal has not returned twice today but then works fine. Bit disappointed after 40,000 miles of very careful driving.... Read more

offshore

That's interesting and has cheered me up!

The last thing I need at the moment is a large unexpected bill - so perhaps it wont be as bad as I think....

movilogo

Please vote here: smartpolls.co.uk/p/24637

Choices are: ICE, P/HEV, EV etc.... Read more

edlithgow

Perhaps I shouldn't have ensured that I and my family were vaccinated against covid, s

Perhaps not....

ItsJinny

Hi there,

New here, but desperately looking for information or signposts. So I apologise if this is posted in the wrong place. I just have to get this information rather urgently as works begin on 23rd Feb 2023.... Read more

badbusdriver

I know this is an old post but ..

...

zensphinx

Hello,

This forum has been very useful for me when trying to find how to fix problems with my peugeot, thank you for the help. I have a problem which has been mentioned before but i cannot seem to fix.... Read more

zensphinx

Just gave it another 30 mins and I can finally put the code in, thank you very much for the help!!

Speedbird 747

Not practical for long distances.

Cost of charging stations too high. Not enough electricity generation to cope.... Read more

Xileno

We've been over all these issues time and time again and quite recently in recent EV threads. I really can't see there's anything further to add and given the likely direction this thread will take I'm putting it to bed early.

Richard_R

Does anyone know if it's possible to find out if a company has been reported to trading standards already? Specifically thinking of a company called

... Read more

Gerry Sanderson

Try a Freedom of Information request to TS of area involved?

dvd...

Steveieb

Sadly the company banking on the EV manufacturing take up in the UK goes into administration.

So what does this say about the UK s future for EV manufacturing.... Read more

alan1302

Nissan have an attached (Chinese) battery factory.Toyota have said if hybrids are banned they will close Derby.

...

galileo

Last week my trusted independent replaced my (83000 mile) original front discs, I also asked for new wheel bearings.

All was fine for a couple of days then I noticed an odd noise when braking from 20 mph or less, frequency depending on speed, sounds like some non-metallic item is catching as the right front wheel rotates. Only occurs when braking, no vibration or pulsing pedal, brakes work smoothly.... Read more

Bolt

edit, irrelevant

I wish I could agree with you but it isn`t the case, many a time I had to change a set of pads due to a problem with a new set of pads causing a noise that the others were not making, and even though everything had been done properly everyone disagreed with what I reckoned....