November 2010
It occasionally will not change up automatically into top gear and has to be done manually - is this a common fault? Read more
Mazda MX-5 2002 51plate 1.8 sport
... Read more
thank you
I've got a 2l Mazda 6 hatchback with 49k miles on the clock and the exhaust has been rattling recently.
The exhaust on the 2l models splits into two just before the rear silencers and the 'Y' piece has a bracket welded onto it that helps to support the exhaust at this point - it is this bracket that has come away from the pipe and is causing the rattle.... Read more
A good welder will make you a new bracket and fit it.
Hi, noticed corsa was loosing coolant the other day, checked it over found coolant running down front of block from head gasket. my question is are the head bolts reusable, and does the cam carrier have to come off, the head bolts seem to be on the outside of carrier. also does the water pump rotate to tension the cam belt or is there a seperate tensioner. I've done afew head gaskets over the years but not on vauxhalls. thankyou for any replies. Read more
no special tool required, there is a dog legged spanner but I have never seen anyone use one !
When you fit a new pump just make sure the housing is clean and use some grease or vasaline around the seal and new water pump bolts as the allen key heads tend to wear and fail when you least need it!
If the old pump is stuck just improvise to remove
This may be a silly question but I seem to have a low tyre pressure on my car. I have relatively new tyres so its not a slow puncture and it effects nearly all tyres. I park on a busy road where there is a fairly steep camber. I dont drive the car very much so it is parked there most of the time. Is there any chance that could be the cause? Read more
Even if they are damaged they can be repaired plenry of firms look in Autotrader if you go for new ones the worlds your oyster just watch out for fakes and cheap chinese copies.
Hi I have just replaced the cup seal and o ring in my master mechanics trolley jack.
I Have filled it with new oil through the fill + bleed cap. The problem i have is that when i try and jack it up with the handle it wil not lock off so i can lift the handle and pump it again.It just see saws between the cylinder and the handle.Has any one had this problem? Read more
I recently (2 weeks ago), bought a Clio 1.2 Dynamique from a second hand garage. Car seemed in excellent condition, 60,000 miles on clock) I have zero knowledge of cars as this is my first car.... Read more
Take the car back from where it came ask them to repair it which is your right.
hi i opened the oil cap and there was yellow gunk under cap the guy i bought it off said he was a machanic and it was only condensation....? as the car was not getting used regularly....it does not overheat... Read more
I would agree, if the car doesn't get used for long journeys it wont get hot enough to evaporate the water
Below is a quick recap of the original post:
I recently received a parking ticket for an offence that I believe I did not commit.... Read more
They must allow an error factor, because if in his notes he has it down as 6 and 1 then 5 and 1, I would ask them what thair allowance is if they respond with 0 then ask them when is 5 a 6 Good luck
As per title, the vibration/ noise seems to be coming from the front passenger side, but that may well be because i have just come out of the car from that side. I find it strange that the sound only occurs after the acceleration pedal is lifted.
Can any one help me out.?... Read more
s*** a brick! that sounds pricey. is it?
Browse
top is normally just a lock up clutch and is controlled by speed. I trust the speedo and ABs are all functioning correctly as this is where some of the signals come from.
It would be advisable to find a indy merc specialist who has good diag kit such as winstar, where they can delve into the depths of diagnostics and live data with ease,as long as they understand what they are doing.