April 2009

Doc

Apart from Little Chef, where can I get a good cooked breakfast in the Guildford area (A31) at about 7am?
This will be a break in a trip to Dorset, so needs to be not too far off the main road.


Read more

Doc

>> Theres a hotel in guildford just off the A3 at the a320 turn.


Update:


The Premier Inn offered an excellent breakfast at £ 7.50 (eat as much as you like)

Recommended.


Danny 3051

My 2002 hdi meridian is riding low on the rear and the o/s inner tyre almost touches the inner arch I'm running on 195 55 15's so nothing too unusual and there's reasonable clearence on the n/s. Kwik fit 'think' it's got and adjustable spline system? or an expensive repair. There's no rumbles or knocking and it rides just clear of the bump stop but sits lower on o/s. Any ideas or advise please ? Read more

rip

Firstly have you posted and searched on www.pug306.net/forum/ there is lots on the rear beam.
Yes they do fail and when they do normally the wheels (one or both) start leaning inwards and the handling invariably suffers too. My car, the Citroen Xsara (same suspension at the rear) had the problem that there was no lean at all, but the rear was seized solid- no movement in it at all. to give you and ides of cost:

Rear beam sourced myself £80
Fitting and new brake fluid £120
Rear shock absorbers £90.

So not cheap but cheaper than buying another car!

ffolliott

Fiat Punto - the dashboard handbrake warning light is coming on when driving at certain quite low speeds but goes off when you stop. The light work fine when you put the handbrake on to park. Seems something is loose or reacting to the forward movement of the car to make a contact somewhere and thus the light comes on.

Not had a really good look as yet but thought I would ask if anyone had had this before or could diagnose the reason.

Many thanks. Read more

oilrag

Don`t the brake lines run across the car in front of the tank Bellboy? As on the Mk2.

I can remember greasing ours... Can`t beat a wipe of grease Rattle (If you read this ;-)

welderjames

hi my rear diff lock has stopped workin,,
does anyone know if its electrical or air operated,,
all fuses are fine,but i cant find an air compressor,,,
oh it was working fine,,and made a 2 second buzzing noise when swiched on and both wheels locked up as expected.
,,,,thanks james,,, Read more

pete&hisgolf

What would be the quickest route from South West Sheffield to Ambleside early on a Saturday morning? I'm aware that part of the A629 near Huddersfield is closed and there is a diversion.

Thanks in advance.

Pete Read more

bell boy

m1 to lee-ads ish
m62a to bradford
find the old road to skipton and keep driving north
lovely
dont do it on sundays though as its full of brain dead motorcyclists (90%) and a real shame

Canterbury

Should a battery which is in good order, retain its charge after it has been removed from the vehicle if it is kept clean and dry in the garage? If so, for how long approximately? Read more

Roger Jones

In case it is of interest to anyone, the Kwik-Fit battery referred to above has just died. Kwik-Fit's replacement price is over £100; I've just bought a Bosch Silver S5004 from Costco for £48.28.

adverse camber

Im getting this message at the bottom of the page


Database error: Invalid SQL: SELECT ip FROM ip_log WHERE ip = '????'
MySQL Error: 145 (Table './honestjohn_db/ip_log' is marked as crashed and should be repaired)

I've replaced my ip with ??? Read more

Stephen

Thanks

Should be fixed now.

----------------------------------
Stephen Khoo
www.khoosys.net

sagard

Hi all,
I have a peugeot806 which I bought recently. Now I have a problem. When AC is on, red led light on temperature gauge starts to flash. What could be the reasone? somebody help..?
Thanks Read more

sagard

I took the vehicle to garage and they changed relay and motor housing; all together it cost me 240pounds. Thanks; I had warranty.
Thanks all of you for your help...

messa

peugeot boxer van 2.8 hdi 2001,smokes for about 2-3 miles then it goes away is it a major issue can any one help.... Read more

messa

......

sinbad

My engine on a 54 plate 1.8 vectra sri code number z18xe is knackered and ive seen an engine for a 2008 sri 1.8 but code is z18xer. Any ideas, cheers? Read more