Hi all,
I have a peugeot806 which I bought recently. Now I have a problem. When AC is on, red led light on temperature gauge starts to flash. What could be the reasone? somebody help..?
Thanks
Edited by Pugugly on 19/04/2009 at 11:18
|
|
You have a problem with the engine cooling fan.This is a 2-speed fan and is very possible that the first speed is not working caused by a fault in the motor.Check the large 2-pin connector plug that is located on top of the radiator.hth
|
When AC is on, fan doesn;t work continuesly; but very on and off...
Any way, I will check this pin...
Thank you..
|
|
|
|
The -pin connector plug you were refering is that one with red plastic top located just above radiator? If it is, its looks ok and anything else to be done?
|
|
In the Peugeot 306, the warning light flashes if the air-con circuit pressure has fallen - either due to a leak or just to gradual pressure loss over several years. Has it been regassed recently?
|
|
When the a/c is switched on,the cooling fan will ,after a few seconds,cut in on low speed.Because the low speed is not working the fan is cycling on/off on the high speed setting.Check the fuses in the engine bay fuse box (near side)This is where the fan circuit relays and fuses are located.There is a method of re-working the circuit with a resistor to overcome the problem with the fan motor,but you will possibly need the help of an electrical tech guy.hth
|
Well...Thanks to all guys for giving me wonderful replys....
I found fuse box under bonnet....but, where is the fuse box under sterring wheel...I checked according to manual book....but my model was diffrence.....
Mine is HDi 2000 model....
so, where can I find the fuse-box ?
Edited by Pugugly on 22/04/2009 at 22:18
|
|
|
I did check both fuse boxes and found all fuses are OK...
So, what could be the problem, then..?
|
I took the vehicle to garage and they changed relay and motor housing; all together it cost me 240pounds. Thanks; I had warranty.
Thanks all of you for your help...
|
|
|
|
|
|
|
