October 2010

Surrey_Scientist

... Read more

madf

DO NOT buy a lead acid battery. As above, they will decay with age. Period.

...

Muggy

( Yes, I have been here recently - just lurking though! )

A couple of weeks ago I had an unexplained puncture on the A361 in Devon; while negotiating the roundabout southbound at the junction with the A399 the front left suddenly deflated.... Read more

Muggy

Yes, there was a valve cap on it.

Bath - no; wasn't much point... after beingdriven on the flat for ½ a mile to the layby and then sitting on it for nearly an hour until the AA turned up it would probably have developed a myriad of small splits! I favour the bracing failure theory above...

speedyxjs

Hi all,

My first post here but have found the search facility very usefull without posting.

I have a Transit Connect in my workshop with a cambelt tensioner failure. I am about to fit the new belt and tensioner but wanted to check what position the tensioner should be in.

Autodata shows the tab opposite the allen key hole lined up horizontal but if i line the tab up with the allen key hole, it is in the ten to five position.

There is a little line on the body of the tensioner which lines up with the tab if i move the allen key hole horizontal.

Sorry for the strange description. Hopefully someone will understand what i am describing ;) Read more

speedyxjs

I beleive its the same as the focus one.

robpaul

Hi All

Twice in the last two months my fiesta has failed to start. What happens is that the the starter motor will work initially but if the engine doesnt start first time and I try to start again then I get nothing at all when I turn the ignition (this doesnt happen always and often I can start the car second time round). If I bump start the car all is fine and I can drive for months without the problem occuring again.... Read more

Peter.N.

I would suspect that your battery terminals need cleaning, when it doesn't start the second time, do you panel lights go out when you try? If not, probably a faulty starter motor or maybe ignition switch.

oldroverboy

Just had second oil change after dealer put wrong oil in and did not fit the offered pattern oil filter ~gfe650 or blueprint adgo2136.

Have used original part #93743595... Read more

gavmoffat

Evening, new to the threads.

I bought a 2000 306 last month and today a strange crackling noise started coming from the air con vent at the passenger's side corner. It's only noticeable when the car is moving, from about 10 mph or so.... Read more

bathtub tom

If you've got air-con then I'd have thought you've got a pollen filter and that should stop anything as large as a leaf - unless of course it's not fitted?

Could it be something as simple as leaves under the bonnet? Lift your bonnet and clear away all you can see, particularly in the area immediately under the windscreen.

Question Nissan Note DPF
markandchrissie

The new 1.5 Diesel Nissan Note from November is Euro 5, 110g/km and has a DPF.Can anyone advise if the current model, Euro 4, 115g/km has one?

I realise all Diesels will have DPFs fitted before long, does that mean that they will all be unsuitable for town driving due to regeneration issues?... Read more

lupofocus

Hi,

my Focus has a plastic trim around the edge of the front windscreen. It has popped out along the top edge and makes a whistling noise. I've tried pushing it back in but it just pops out again. Any ideas as to what would be safe to use to glue it back in? So far I've thought about using silicone sealer or plumber's mait. I'm not sure about either. Whatever I use it would need to be flexible, not cause any damage and not cause a problem if the windscreen needs replacing. Any recommendations?... Read more

The_Outsider

Just put a deposit down on a Y reg Ford Focus, the problem is that there isnt a remote keyfob with the car. Any tips on where to buy and if/how they can be programmed?

Thanks Read more

carol-anne

are the police obligated to post detours after a road accident when the road is closed for hours Read more

Dutchie

Long time ago in heavy machine shop on the milling machines.Started on day shift the famous wales rugby player Clive Sullivan worked on day shift.I carried onto permanent night shifts needed the extra cash.