What do you think of Elon Musk? Have your say | No thanks
01 2.0 Aftermarket Gear stick Lock - Simoncelli58
Hello,I've got a Multi-lock fitted to my Vectra and I'm trying to find a way to remove it !
I've taken the lock itself off, but I'm stuck with the metal plate that comes up to the left of the Gear stick. Is it welded to the underneath of the car or is it bolted ? Can I get access from underneath or do I have to remove all of the trim inside of the car?
Or, will it have to be cut out (not much room for an angle grinder).
Any help at all would be very welcome.( If you need to know the reason, its because it never gets used and its big and ugly).
Thanks.

Edited by Dynamic Dave on 06/12/2009 at 14:13

01 2000 Aftermarket Gear stick Lock - Simoncelli58
Sorted ! Moved all the trim out of the way, then half an hour with a Junior Hacksaw. One hard piece of Steel !
01 2000 Aftermarket Gear stick Lock - Victorbox
What was it bolted to? If it was the floorpan do you now have a hole?
01 2000 Aftermarket Gear stick Lock - Dynamic Dave
Didn't Edd China have to remove one of these, or something very similar from A BMW (I think) on the TV programme Auto Trader that also starred Mike Brewer. Not an easy task from what I recall.
01 2000 Aftermarket Gear stick Lock - Simoncelli58
No holes-I cut the plate in two leaving a chunk bolted to the floor pan.I couldn't get enough access with out a ramp or a pit ! I cut below the level of the trim.All hidden now. Cant see the point in these things when the car has a factory fitted immobiliser ?
01 2000 Aftermarket Gear stick Lock - jc2
BiL had car pushed up road,then loaded on trailer-not started.