01 1.8 Zetec setting TDC - Stewart_2004
Hi Everyone Im trying to set my Zetec to TDC as I want to make sure everything is timed up ok. I have The laser camshaft and crankshaft tools but do I insert The crankshaft pin first then turn engine over by hand until it stops against the pin or do I allign the two machined ends of the cam and insert the bar ? In haynes it says to rotate the crank till the intake cam has just closed. Is the intake cam the on nearest the bulk head ?

Any help would be great.

Regards

Stew

Edited by Dynamic Dave on 19/03/2009 at 18:20