Most recently answered brakes questions
Can you tell me the size of the brake calliper bolts on the front brakes of a 2006 Toyota Yaris 1.0L T3? I have tried an 11mm and 12mm socket but the bolt does not appear to be moving out of the thread....
My Citroen Saxo VTR recently failed an MOT due to the offside rear brake producing little or no effort. I had to replace the calliper, discs and pads on the rear of the car anyway, but this has not resolved...
I have a 54 reg Peugeot 407 SW HDI. When I first start up the brakes are inoperative as if with no servo assistance. The pedal is hard to push and when pushed has little effect on braking. If I wait with...
My granddaughter has a 2007 Polo 1.4. Two days ago she started the car as usual and endeavoured to drive off. She released the handbrake and found that the car would not move (it seemed to be straining...
My 1992 Vauxhall Calibra has the brake system light and the alternator light coming on, and the worn pads light as well. The brake light and alternator light started intermittently and dimly, and now they're...
My wife was driving our 2004 Ford Focus 1.8 petrol model yesterday when the steering became heavy and the brakes hardly worked. The onboard computer displayed the messages "engine system failure" and "braking...
I have a 2000 Volvo S80, mileage 112,000. The ABS light has come on and my main dealer says the part will need replacing at an overall cost of roughly £1200. I am hoping that servicing or repair is possible...
I have a Toyota RAV4 D4D registered in Sept 2007 and it has done 30,000 miles. On applying the brakes the steering wheel is juddering, which, according to the Toyota dealership, is due to the disxs being...
I recently bought a Citroen Xsara Picasso 1.6HDi (2005) and, after about a week, noticed that there was a squeaking noise coming from the front driver's side wheel. This has got progressively louder over...
I have just changed the front disks and pads on a 2002 Volkswagen 2.0-litre petrol Passat. All the bolts and guide pins on the caliper and clamp are tight and torqued correctly, as are the wheel bolts....
Elsewhere on 
