The problem I am experiencing, since purchasing secondhand from Car Giant, is that the driver's side power window switch, which operates the driver's window, does not operate the othe three windows. These windows operate independently however, through their own switches, so I replaced the power switch but with no success; it works in exactly the same way, the lights, on the switches for the three windows, go on and off with the operation of the isolator button.
I will look at the fuse/relay block by the passenger footwell soon, when I come back from holiday next week, but if anyone out there has had an experience like mine and rectified the problem, I will be very obliged to be given the solution.
tedmurphy41
|
I'm sure that I read a post somewhere with a similar issue; the fix was a similar reset.
I'll have a search on this site.
|
This is the one that I was thinking of which is different sorry.
This is a quote from the workshop manual
Note
? A driver side window will not fully close automatically under following the conditions:
? The battery has been disconnected during vehicle maintenance or for other reasons.
? The power window main switch connector, or driver-side power window motor connector has been
disconnected.
? Carry out the following procedure to resume operation:
1. Turn the ignition switch to the ON position.
2. Press the driver side power window main switch and fully open the driver side window.
3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window,
and keep holding the switch up at the position for about 2 seconds to complete initial setting.
TWO-STEP DOWN FUNCTION OPERATIVE/NON-OPERATIVE SWITCHING PROCEDURE
Note
? By following the procedure below, the two-step down function is switched to non-operative when it is
operative, and to operative when it is non-operative.
Turn the Ignition on
Within 5 sec
perform the auto open two times
perform the auto close two times
turn the ignition off and within 40 seconds and repeat the above sequence.
Repeat for all the windows.
|
|
Hi. I had same problem on my Mazda 5 2005 . So by above posted instructions I sorted out this problem. This saves me many £££ . Thank You very much.
|
I have 2009 model and after a battery disconnect, the one-hit window switch failed to work on driver's and n/s rear passenger's windows. Strangely the other 2 worked fine.
To fix I did a variation of the above:
Ignition "on"
Lower affected window using part way down switch position to the fully open state, then raised window, again using part way position and keeping it in place for 2 seconds once shut.
Repeat for ALL windows.
Works one now. Thanks for the guidance guys, just goes to show Mazda still using these type of reset tricks in later model too!
|
|
|
