03 1.6 ABS light remains on after sensor repair - cjm1066
Had to replace the o/s/r ABS sensor due to a broken wire, however the ABS light is still on, is the new sensor defective, or do I need to reset anything?

Tweak to subject line

Edited by Pugugly {P} on 21/10/2007 at 22:24

ABS light remains on after sensor repair. - eastenddoy
it will have to be reset by some one with a code reader
ABS light remains on after sensor repair. - Screwloose
cjm

Did you have the faultcodes read before, or after, you changed that sensor?

What year and model Focus is it?
ABS light remains on after sensor repair. - Simon
Will disconnecting the battery for say 30mins not force the ABS system to reset itself and if all is okay turn off the light?
ABS light remains on after sensor repair. - cjm1066
Thanks for the help, the wire got broken getting the sensor out of the hub, that's when I replaced the sensor but as yet the codes haven't been read.

Is the Gunson code reader any good for this task www.gunson.co.uk/item.aspx?item=1809&cat=443


ABS light remains on after sensor repair. - Screwloose

That code-reader will only read engine codes.

To look up the correct info needs the correct vehicle details....

So; once again:-


WHAT YEAR AND MODEL IS IT?
ABS light remains on after sensor repair. - cjm1066
Sorry, its a 1600cc 03 LX.
ABS light remains on after sensor repair. - Screwloose

From that year onwards; it will need a scantool to erase the codes.