Ford Focus diesel losing power

I had a problem with the turbo on my Ford Focus 1.6 diesel (2007 model). The bearings failed due to a blocked oil strainer. I went for a refurbished BTN turbo replacement with the full fitting kit (oil strainer, new oil feed pipe and banjo bolts, new seals).

I took the sump off, cleaned it totally, cleaned the all pipes going too and from the turbo and fitted it with a new oil filter and change of oil.

Now I have it going but it seems very sluggish in power. The turbo is operating, but I'm not getting the same boost I was before. Any ideas what could be wrong?

Asked on 30 April 2015 by J-Focus

Answered by Alan Ross

Would suggest that at this stage you carry out a diagnostic check to see if you get a fault code/s.( should be P ---- 4 numbers) .
Doing this will then clarify if you have any sensors at fault.

Tags: loss of power diesel engines technical issues

Similar questions

Is a loss of power in my Audi A3 a symptom of the emissions fix?

Since my Audi A3 had it's emissions fix it has had problems with the engine management system light flashing intermittently and the engine losing power. I've taken it to the Audi garage today and they're...

Land Rover Freelander power loss

My Land Rover Freelander 2 TD4 suffers from an intermittent lack of power when pulling away from junctions. I've had a new clutch and flywheel fitted, along with EGRE valve and throtle flap motor. The...