Hello All,
Non ABS Fiesta - 3 door hatchback - endura engine. I've got new drums for the back cause the old ones were slightly oval and rubbing - plus a lot of rust too.
The new drum is missing the bearing bit - is this something I need to purchase and fit - or purchase and get a garage to do?
Cheers,
James
|
Yep, you'll need bearings for the hub/drum. Not difficult to install just need a big hammer and socket or drift a few thou' smaller than the outside diameter of the bearing race.I use an old impact socket to carefully and squarely drift the outer races into the hub. make sure you fit them facing the correct way and work some high melting point grease into the roller bearings.
|
Hi Andrew,
thanks for that - i'll probably drop them into the local garage - so its done square!
Cheers
James
|
|