|
if i put a 1.3 engine block in my 93 1.1 fiesta will i need to change anything else
|
Hello.
How old is the 1.1 and how old is the 1.3
I would replace the oil pump to ensure that you get full pressure
And replace the water pump too.
Hope this helps
--
(iam not a mechanic)
Martin Winters
|
|
|
What exactly are you changing? The whole engine or just the block?
Engine oil pump is exactly the same, I assume the same is true of the water pump, though I'm not 100% on that.
Apart from that, everything is different on the 1.3 vs 1.1, including bore, stroke, and head. Also the 1.3 CFi HCS has a funny exhaust gas heat exchanger which helps cold starting, though you can block the holes in the head and just not use it. Also remember that CFi HCS engines have a lower compression ratio than carb. engines, denoted by a bowl in the piston head. Plus you're looking at a different engine in terms of ignition and fuel mapping.
Unless I had all ancilliaries, I wouldn't do it, though I'm sure someone will be along to tell you how soon :-)
--------------
Mike Farrow
|
|
It is usually a good idea to put a new clutch in while the engine is out,not forgetting the release bearing.
|
Hello.
Iam asking that you change them because they will be quiet worn not because of changes.
--
(iam not a mechanic)
Martin Winters
|
Sorry Martin, yes, I understood what you were saying when I read it again.
--------------
Mike Farrow
|
|
|
|
