citroen berlingo van 04 dw8 engine - engine re-placement

Honest John Back Room » Technical matters
View Threaded
Fri 28 Nov 2014 21:34
citroen berlingo van 04 dw8 engine - engine re-placement - Micky-BO

I have purchased a second hand replacement engine from the breakers for this vechicle already fitted with h/pressure pump. Does any 1 know if this pump needs re-coding or would i need to fit the orignal pump off the old unit. Any feedback greatly accepted Regards Mickeybo

Reply | Report as offensive | Link
Fri 28 Nov 2014 23:30
citroen berlingo van 04 dw8 engine - engine re-placement - Peter.N.

The one on the Hdi doesn't but yours has an injection pump doesn't it? that will have an immobiliser which may need use of a Lexia. It might cause less problems to swap the pumps over only mark the position of the pump on the mounting flange and the pump before you change it.

Edited by Peter.N. on 28/11/2014 at 23:32

Reply | Report as offensive | Link
Sat 29 Nov 2014 08:44
citroen berlingo van 04 dw8 engine - engine re-placement - elekie&a/c doctor

As above,use the original pump if poss if it was ok before.Make sure it is the same type on the replacement engine as you may find the mountings and installation points different.If they are not able to be swapped,then you can remove the immobilser electrics and just use the regular stop solenoid.However to do this it will be reqd to grind off the metal security plate.

Reply | Report as offensive | Link