| Hello.. 
 I have an S reg ford fiesta, recently my heating died and I replaced the heater valve; which cured the problem.
 
 Now, after about 3 weeks the heating is only blowing cold AGAIN. I've checked the valves connected, the 2 valves from the engine are hot, the two valves going into the car are cold - So the problem is halfway (Heater valve unit :/)
 
 Unless, is there anything else that can be causing this? Or is it definitely a dead heater valve controller, again..
 
 Thank you,
 
 Phil.
 | 
            
            
                
                
                    | These valves have been known to fail so I would think that is the most likely problem, otherwise the matrix could be blocked, but if the water is clean with plenty of antifreeze, unlikely. | 
            
            
                
                
                    | my mate removed the motor off the valve and pulled out a filter and cleaned it,it was full of antifreeze and then replaced the motor and now works fine again 
                                Edited by atlantic on 21/02/2010 at 20:21
                             | 
                    
                        |  |