Peugeot 406 (1996 - 1998) - 1996 2.0 Replacement of Indicator Stalk | Technical matters | Back Room Forum

Mon 1 Dec 2008 22:52

1996 2.0 Replacement of Indicator Stalk - vvprabhu

I got a Indicator stalk from the breakers for my car and have trouble replacing it. I thought it is as simple as to remove the steering cover and replacing the stalk but its turning out to be tricky.

Questions :

1. what screw driver will i need for the steering cover? (the two screws on the bottom side)
2. will I need to reset the ECU for airbag etc if I replace indicator stalk ?

Reply | Report as offensive | Link

Wed 3 Dec 2008 12:31

1996 2.0 Replacement of Indicator Stalk - RichardW

1. Probably a T20 or similar - get yourself a cheap set of Torx bits that will allow you get them undone (there's probably more than one size)
2. Unlikely on a 1996 car.

On similar aged Xantias you need to remove the steering wheel to remove the column covers, as the top one goes over the steering column - check this is not the case with yours.

Reply | Report as offensive | Link

Related questions

Is it better to have a service before an MoT?

Can you please tell me what the advantages and disadvantages are of having a service before or after an MoT?

How do you test an AWD system is correctly working?

How do I test an AWD system on a test drive?

Is having only one fog light an MoT failure?

I own a Ford Kuga Titanium PHEV and during its second service the Ford garage found that one of the lamps was not working and asked if I wanted to have the problem investigated at a cost of £105 (they...

I bought van and have discovered it has differing VIN numbers - where do I stand?

I bought a van a year ago with an MoT. I went to renew the MoT and was told that it has different VIN Numbers. Where do I stand to give it back?

Ask Honest John

Sell Your Car

Real MPG

Fuel Calculator