paint spraying - flatfour
I want to know the easiest paint to use for a respray, i'm confused with cellelose and 2pack, most of my body repairs are finished in hammerite No.1,
paint spraying - Sooty Tailpipes
Hmmm, I only ever made one DIY attempt and the paint factor recommended 2 pack, as it is more durable. The results were excellent, however, if you use two pack, the fumes are very poisonous to the nervous system, and you should wear a full air-fed suit, but I did it outside, and wore a orgnaic gas filter mask which was from machine mart.

The paint was easy to work with and the results were excellent.
I only used a £28 machine mart clarke spray gun, but the compressor was a bit small, and I had to keep waiting for it to 'catch up' and fill the receiever, so a 50 litre one is recommended.

Most of all, spend 10x longer doing the preparation, than you do painting.
Start with the edges, and let them dry, then do the face of the panel, starting at the bottom and working up- this stops sagging and new-edge runs.
paint spraying - Dynamic Dave

Two pack is not for the average DIY'er. Two-Pack paint is an isocyanate and should only be applied while wearing suitable safety clothing (i.e. a Tyvek suit), goggles and an extractor mask so the cyanide cannot be absorbed through the skin or ingested.

paint spraying - Civic8
Apart from what DD said.two pack.has to be used in a sealed garage with filters much the same as your own clothing.to prevent release into the air.
--
Was mech1
paint spraying - Crinkly Dave
have a look at www.hse.gov.uk/pubns/indg388.pdf
www.hse.gov.uk/mvr/coshhessentials.htm
on www.hse.gov.uk/mvr/main-illhealth.htm

Get it wrong and symptoms start 2 - 3 hours after exposure
paint spraying - BB
The main reason/benefit why you should spray indoors in a sealed room is to stop contamination. As long as you have no-one near you when spraying, isocyanates soon disperse into the atmosphere if spraying outdoors.

Try and wear a mask though!
paint spraying - BB
Forgot to mention, wear the overalls suggested above too.
paint spraying - Civic8
I should have said extractors with filters.I think its the law.
as cyanide is a killer it has to be.anyone trying to use two/pack in anything other than recommended circumstances are asking for trouble.the reason for filters are to prevent the isocyanates reaching the atmosphere.I know it is illegal to use without.
--
Was mech1
paint spraying - Sooty Tailpipes
I asked the man at the paint factors about the cyanide when he recommended it, and he screwed his nose up and said, yeah I know, but loads of people don't bother, as long as you do it outside and avoid the fumes, and wear an organic respirator, he said it's if you're doing it all day every day inside or getting it on you that it could be a problem.
Well, you just have to treat it with respect, wear thick layers of clothes, no bare skin, shower cap, goggles, gloves etc..... and don't sit around near the car when you've done a coat. I didn't go mad, and I'd use it again......In fact, superglue also gives off cyanide, and eating a cup full of apple pips contains enough cyanide to kill you!
paint spraying - Victorbox
Several articles in Practical Classics mag have suggested that the sale of two-pack paint has been tightened up. Unless you can prove you are in the vehicle refinishing trade (presumably with an account with the paint factors) you won't be able to buy any two-pack paint.
paint spraying - BB
I spray a lot of PU based material at work, if there is any volume to the work you are doing (we do 30,000 units a year!) you should spray inside in a filtered room with extraction across the part of at least 0.5m per second. (This also helps carry overspray away from the part.)

Not that I advocate the spraying of isocyantes by anyone, but..

if anyone is going to spray on the diy, it is best to do it outside and NOT in a non-extracted room. In a non-extracted room, the isocyantes have nowhere to go, outside they disperse. Spray with the wind on your back.

As stated earlier by others, a paper suit (with a few layers on underneath,) a respiratory mask and a suitable pair of non-breathable gloves is what you need to be on the safe side.

paint spraying - flatfour
Thanks for all the info, I think i'll use cellulose, i've got a carbon filter mask so should be ok.
paint spraying - Dynamic Dave

There's also acrylic, which IIRC, is less prone to fading than cellulose is.
paint spraying - John S
I'm intrigued by the DIY use of two pack. The two pack I've used(with all the precautions noted) needed oven curing - I don't believe it would cure at room temp. It's certainly durable. is there an 'air dry' version?

JS
paint spraying - Sooty Tailpipes
The stuff I have was from.....
www.hex.co.uk/home.htm

It didn't need an oven or infra red lamp, it just cured on it's own, I even use the lacquer mixed up in an aerosol lid on my new car, as touch up with a brush as it's much better than the nail varnish you get from the dealer/halfords etc...
paint spraying - Civic8
S.T I think your comments out off order due to health risks.you of course are welcome to use what you like.but would suggest any health risks that you think is ok.use for yourself.dont advise others to use it knowing/thinking it is ok.it for a long time it has been known spraying with 2/pack is dangerous hence regulations.if you dont others are and will be affected.?
--
Was mech1