I have a MkII golf driver - 1991. It recently lost the wheel arch cover on the front passenger side revealing a fair amount of corrosion.
This extends right down to the plastic valance fixing which has been rotted out.
Ok, its not a structural problem but i want to get it sorted.
Do I rebuild the wing with fibreglass putty & zinc mesh - which I have never attempted before, or do I find a new wing and get it fitted at a garage?
The former would take a long time, so I would like to replace the wing, but my funds are shall we say - low.
How do I go about it?
Do I go to a wreckers yard?
Where can I find a suitable yard?
Will they be able to get the part off a car for me?
Can I just hand the wing in to a body specialist and they fit it?
What else do I need e.g. new arch moulding?
How much will parts + labour cost?
Any replies will be gratefully received.
|
From memory the wing is bolted on as opposed to welded, I would try to source a good wing in the same colour from a scrapper and get it fitted. Even a similar colour wing is going to look better than anything you are going to attempt with filler. Also much less labour involved in bolting a wing on than all the prep, filling, sanding, painting of the old.
Good luck
|
|