solex carb je3 idle & mixture screws

Honest John Back Room » Technical matters
View Threaded
Sat 18 Oct 2003 11:50
solex carb je3 idle & mixture screws - Shep Jones
I have a citroen zx 1360 cc 1975 it started to run rich I can't find the screws to adjust on the carb,any ideas.Regards Shep.
Reply | Report as offensive | Link
Sat 18 Oct 2003 20:47
solex carb je3 idle & mixture screws - RichardW
Assume you mean 1995? In which case it will be injection?

Even if it is carb, adjusting the idle and mixture screws only affects the mixture at idle, it will not cure a rich running over the full rev range problem, which is more likely to be a carb fault of some sort.

Richard
RichardW

Is it illogical? It must be Citroen....
Reply | Report as offensive | Link
Sun 19 Oct 2003 07:55
solex carb je3 idle & mixture screws - Shep Jones
Oops! it was 1995 but not injection and of course it is a Citroen ZX, I probably have to get a recon kit ie jets etc.Many thank for your reply.Shep.
Reply | Report as offensive | Link
Sun 19 Oct 2003 18:15
solex carb je3 idle & mixture screws - Dynamic Dave
Oops! it was 1995 but not injection....


It will be injection. More than likely it will be fitted with single point injection. All petrol cars built from 1993 onwards are fitted with catalytic convertors. The injection system is more accurate at monitoring fuel/air than a carb.
Reply | Report as offensive | Link
Sun 19 Oct 2003 00:21
solex carb je3 idle & mixture screws - Caveman
Haynes manual perhaps?
Reply | Report as offensive | Link
Sun 19 Oct 2003 07:38
solex carb je3 idle & mixture screws - Shep Jones
Thanks for the reply, I do have a Haynes manual but it does not have my model carb.Regards Shep.
Reply | Report as offensive | Link
Mon 20 Oct 2003 20:26
solex carb je3 idle & mixture screws - Adam Going (Tune-Up)
Shep,

Watch my virtual lips -- as DD said, your car does not have a carburettor. It may look like one to you, but it is a single-point fuel injection unit. Mixture is controlled by an Electronic Control Unit (ECU) in response to inputs from various sensors on the engine. There is no adjustability - if it is running lean or rich it requires knowledgable diagnosis, and rectification could involve anything from a dodgy connection, through a replacement sensor or sensors, or even an ECU fault.

As these components can be very expensive correct diagnosis is essential.

Regards, Adam.
Whatever is rightly done, however humble, is noble.
Reply | Report as offensive | Link