Videos showing basic tasks

Honest John Back Room » Technical matters
View Threaded
Mon 2 Nov 2009 19:54
Videos showing basic tasks - Gregory II
I have looked on youtube etc, and I would like to find videos showing three tasks I would potentially like to do on my motorcycle. I would love some very clear and detailed videos from knowledgeable people. Can anyone suggest some:

1. To drill out rusty/ seized bolts. Techniques for this.
2. To make new threads for bolts
3. Change a clutch on a car/ motorbike

I would like suggestions from start to finish. I did find one or two that gave just snap-shots!

Thanks
Greg

Edited by Pugugly on 02/11/2009 at 20:09

Reply | Report as offensive | Link
Tue 3 Nov 2009 09:57
Videos showing basic tasks - piston power
1, This can be found in most engineering books, centre pop the broken stud drill with small drill working you way up to the larger one and use a easy out to remove, you may have to use some penatrating fluid or heat.

2, Again drill to size for a 10mm thread a drill of 8.5mm then a starter tap & then the finishing tap to make the thread. in a kit there is usually 3x taps i just use 2.

Same for dies use some oil when cutting the threads it makes it a much cleaner and easier cut.

3, This can be found in Haynes manual.

On you tube looks for Davids farm a canadian guy bit of a nut but his videos are good and interesting he covers auto boxes, transmissions engines & plenty of other crazy stuff.
Reply | Report as offensive | Link