Peugeot 406 exhaust flexi

Honest John Back Room » Technical matters
View Threaded
Wed 17 Aug 2005 10:40
Peugeot 406 exhaust flexi - kyle richmond
On my 406 hdi (90BHP) 2000 the flexi pipe has gone on the exhaust, this flexi is in 1 piece with the cat, i do not want to purchase the cat as it is fine and very expensive, i just want to replace the flexi, however i have been offered a flexi and cat extremely cheap but i belive it is for the 110BHP) enging although they look very similar, would this fit if i where to cut and clampthe rear section to join the new piece in place and are the brackets in the same positions
Reply | Report as offensive | Link
Thu 18 Aug 2005 14:03
Peugeot 406 exhaust flexi - ssray
as you dont need a cat for the mot on a diesel why dont you just replace the cat and flexi with a longer bit of flexi? this should improve performance and poss mpg(not while using extra performance)
Reply | Report as offensive | Link
Thu 18 Aug 2005 14:14
Peugeot 406 exhaust flexi - Collos25
Hdi engines as used in Pugs and Citroens attract a lower exise duty £115 and as such the exhaust emissions should be measured a certain failure point.If the replacement Kat is in good order go with it as removing it could cost you dearly in the end.
Reply | Report as offensive | Link

Exclusive to Honest John users: 12% off ALA GAP Insurance

Reader Offer: 12% off ALA GAP Insurance

10 warranty myths exposed

Here’s how to sort the fact from the fiction when it comes to car warranties.

Cheap Car Warranties